Advertisement
TROUBLESHOOTING
NOTE: For problems not so
P
roblem: No reception of WWVB time signal.
Solution: 1) Wait overnight for signal.
2) Be sure indoor weather stat
controlled clocks.
3)
Remove batteries fo
4) If there are still problems, contact La Crosse Technology.
Problem Hour is incorrect (minute and date are correct).
:
Solution: Be sure correct time zone and daylight saving tim
P
roblem: The LCD is faint.
Solution: 1) Set the LCD con
2) Replace the batteries
P
roblem: No outdoor temperature/humidity and/or wind speed is displayed.
Solution: 1) Disconnect the cable from the remote wind speed sensor, then re
2) Remove all batteries, reinsert into remote temperature/humidity sensor first, then the indoor weather station.
3) Place the remote temperature/humidity sensor closer to the display.
4) Be sure all batteries are fresh.
5) Place the remote temperature/hum
passing through more than two or three walls.
P
roblem: Temperatures do not match if units are placed next to each other.
Solution: Each temperature/humidity sensor is manufactured to be accurate t
conditions, so two sensors could be as much as 4 degrees different. However, the difference can be exaggerated furthe
because the sensors are designed for different working environments. The indoor temperature sensor is less responsive to
ambient air currents because of the shielding effect of the display's case. In addition, the case can act as a heat sink to abso
and store heat from external sources (i.e. handling of the case or radiant heat). Also, the much greater range of the remote
temperature/humidity sensor requires a different calibration curve than the indoor range. Error is usually greater at the
extreme ends of a range, making it harder to compare different ranges with different curves. Under non-laboratory
conditions, it is difficult to compensate for the above factors and obtain an accurate comparison.
M
AINTENANCE AND CARE INSTRUCTIONS
•
Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units.
•
Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; th
casings.
•
Do not sub
merge in water.
•
Immediately remove all low
•
Opening the casings invalidates the warranty. Do not try to repair the unit. C
SPECIFICATIONS
W
eather Data Measuring Range:
Indoor:
Outdoor and dew point:
Wind chill:
Indoor relative humidity measuring
range:
lved, please contact La Crosse Technology.
ion is at least 6 feet from any electrical devices, such as televisions, computers, or other radio-
r five minutes, reinsert and leave the unit alone overnight without pressing buttons.
trast to a higher number.
idity sensor and indoor weather station in position so the straight-line signal is not
powered batteries to avoid leakage and damage.
14.2°F to 139.8°F with 0.1°F resolution
(0°C to 59.9°C with 0.1°C resolution)
"OFL" displayed if outside this range
-21.8°F to 157.8°F with 0.1°F resolution
(-29.9°C to 69.9°C with 0.1°C resolution)
"OFL" displayed if outside this range
-21.8°F to 157.8°F with 0.1°F resolution
(-29.9°C to 69.9°C with 0.1°C resolution)
"OFL" displayed if outside range
1% to 99% with 1% resolution
("- -" displayed if outside this range
e settings are selected.
insert making sure the cable clicks in place.
o within 2 degree plus or minus and under normal
ey may mark the displays and
ontact La Crosse Technology for repairs.
r
rb
Advertisement
