Page 2
INTRODUCTION Dear Customer, tractor tractor sales centre. For easier reading, tractor IMPORTANT - machine showing pictographs illustrating the main operating precautions of the machine, the user is therefore responsible for replacing them in the event of their becoming detached or illegible.
Page 4
WARNING SYMBOLS DEFINITIONS OF SYMBOLS WARNINGS! familiar with the controls and the proper use of the equipment. tractor HAZARD - HAZARD - operations on the machine, and before unblocking the grass unloading in the manual. HAZARD - HAZARD - and all the moving parts to come to a halt before touching them. The blade will continue turning for some time after switching off the engine or disabling the blade control.
Page 5
WARNING SYMBOLS HAZARD - Risk of overturning on steep gradients. > 25% > 25% > 15% HAZARD - Risk of overturning on steep gradients. Do not use the machine on lawns with gradients of more than 25% (14°). Do not use the machine on lawns with side gradients above 15% (8°). HAZARD - Hot surfaces: danger of burns.
INSTRUCTION MANUAL TRAINING focus in particular on: - being careful and concentrated during work; - the fact that a machine sliding down a gradient MACHINE cannot be controlled using the brakes. HAZARD! The main causes of losing control of the machine are: "SAFETY PRECAUTIONS", before, - lack of wheel grip;...
INSTRUCTION MANUAL up or down. ged. blade, the blade fastening screws and the slopes. cutters are not worn or damaged. Replace lawns and when the lawn tractor is transported fastening screws in complete series to maintain to and from the work area. tractor proper balancing.
INSTRUCTION MANUAL C 15 Disengage the blade during transport and sons starting the machine. C 16 disengage the blade: check, the tightening of the blade and of the - before leaving the machine; engine supporting bolts. D 11 Blade sharpening and balancing adjustment, - before removing the grass bag;...
(see attached engine manufacturer’s manual). (for model DUELT24-4 only) provides the power to start the internal packaged in a metal crate to protect it during tran- combustion engine.
(part 2) and the nut provided. Tighten well. part 1) once positioned. part 2) and the nut provided. Tighten well. BATTERY (for model DUELT24-4 only) IMPORTANT Position the front half-shell and make the screw for the 6 elements. following instructions relating to “how to adjust the forward/backward position of the seat, to best suit the driver.
INSTRUCTION MANUAL being careful to keep it in “vertical” position. DO NOT hold it at an angle. and the correct alignment of the blade with the shown on the technical data table. rate the sealed tangs of the bottle and thus allow 3) Replace the multiple cap and press it well down servicing the engine itself.
- To switch from one gear to another, at mid stroke move the lever to the required position. IMPORTANT chapter. To enable the controls (subse- 4.3 and 4.4. for model DUELT24-4 ) if inserted and turned (pos. "I" INSTRUMENTS enables manual engine start. If turned to position, switches off engine.
INSTRUCTION MANUAL engines with power start also feature cable start. (for model DUELT24-4) To start the engine: 1) Operate the parking brake. reduced or increases engine revs. cold starting CHOKE # Release the brake/clutch pedal. This will remain engine minimum speed 2) Lift the blade deck as far as it will go.
INSTRUCTION MANUAL MOVING CAUTION sing. Never change direction of move- CAUTION gradual to prevent sudden engagement of the drive causing the vehicle to jump Move the speed change lever as required EMPTYING THE GRASS BAG If the cut grass remains on the ground, this means Increase the number of engine revs (if too the grass bag is full: low).
INSTRUCTION MANUAL # In case of blockages and drops in engine speed, engage a lower gear and further raise the blade deck. ater cutting height to prevent the blade knocking follow the instructions in the chapter: “Ba- damage to the blade and mechanical parts. CAUTION When cutting on slopes, redu- ph "1.4"...
INSTRUCTION MANUAL HAZARD - Blade sharpening and balan- cing adjustment, including removal and reasons, these operations must be carri- The same applies to blade replacement with a new one. MACHINE # Do not use high-pressure nozzles or aggressive liquids to wash the casing and the engine. ENGINE To service the engine, follow the instructions in the attached engine manufacturer’s manual.
INSTRUCTION MANUAL SHARPENING AND BALANCING THE BLADE 5.3 DISMANTLING Check that the blade is sharpened properly and firmly fixed to the bracket. – A badly sharpened blade pulls at the grass and causes the lawn to turn yellow. – A loose blade causes unusual vibrations and can be dangerous. WARNING! All operations on the blade (dismantling, sharpening, balancing, remounting and/or replacing) require a certain familiarity and...
, k=1.5 m/s Forward movement speed (theoretic with engine revs 3000 /min) -In first gear 1.5 km/h -In second gear 2.5 km/h -In third gear 3.5 km/h -In fourth gear 4.5 km/h -In reverse 1.5 km/h Weight (model DUELT24-4) MACHINE DIMENSIONS...
Need help?
Do you have a question about the DUELT24-4 and is the answer not in the manual?
Questions and answers