Panasonic WX-ST600P Operating Instructions Manual page 15

1 P ower switch [OFF/ON]
Turns the microphone ON/OFF. It is a slide switch.
2 C harge indicator (USB)
Shows the charge status.
On (red)
Blinking (red)
Off
3 T alk indicator
Indicates the talk status.
On (green)
On (red)
Blinking (red)
Off
4 S tatus indicator
Shows the battery status.
On (green)
On (orange)
On (red)
Off
Blinking (green) : Connected to the settings support software (while the simplified
Blinking (orange) : No signal (outside of the connection area between microphone and
Blinking (red)
Alternately blinking (orange/green)
5 M icrophone connector (WX-ST600P only)
The connector into which the gooseneck microphone is plugged.
6 M icrophone unit (WX-ST700P only)
Collects audio.
7 T alk indicator
Indicates the talk status.
On (green)
Off
: The Ni-MH batteries inside the product are being recharged via USB.
: Charging error (primary battery / battery short / temperature
abnormality detected / battery not inserted).
: Charging completed, or power supplied via USB to this product, but
there are no batteries inside.
: Talking
: Not talking
: Talking and the receiver channel is muted
: No signal (outside of the connection area between microphone and
antenna) or microphone unpaired with a receiver
: Power ON
: Power ON (less than one hour of battery runtime remaining)
: Battery almost depleted (recharge or exchange the batteries)
: Power OFF
spectrum analyzer and slot monitor are running)
antenna)
Pairing mode
: Microphone unpaired or failed to pair with a receiver
● See "Pairing" (page 24).
: Confirming pairing
： Talking
： N ot talking or no signal (outside of the connection area between
microphone and antenna), or microphone unpaired with a receiver
15