Table of Contents
Advertisement
SAFETY PRECAUTIONS
WARNING
Machine ：
Electrical safety
* The counter, safety device against excess current and electrical installation, are
* The connection, single-phase or three-phase, is possible on a stand compatible
* If the cable is connected with the electrical network, the earth must never be cut
Work place ：
* Be very careful to avoid contact between metal part and phase conductor and the
* Electrical messes of different electrical machine and apparatus are connected
Interventions ：
* Before control and repair, see the apparatus is switched off and insulated.
* Connection with fixed installation cable is impossible.
* It's on "STOP" and connection is impossible.
* Some apparatus are provided with starting circuit HT HF (with a plate). Never
* Only qualified persons are authorized for intervention concerning electrical
Maintenance
﹡ Often check the insulation and connection good state of apparatus and electrical
* Maintenance and repair of insulating coatings operations are very important.
* Do repair with a specialist or better replace defective accessories.
* Check regularly the right adjustment and the non-heating of electrical connections.
Individual safety
* The operator must be dressed and protected in relation with his work.
* Avoid contacting metal parts connected or accidentally connected.
* Wear leather gloves with gauntlet.
* Safety clothes: gloves, apron, safety shoes protect the operator and his assistants
Operation and maintenance involves potential hazards. All operators and
personnel should be alerted to possible hazards and precautions should be
taken to prevent possible injury.
compatible with its maximum power and its main voltage.
with the plug of its cable link.
by the protection device against electrical shocks.
neutral of electric network.
between themselves and with the terminal of earth neutral wire.
enter into the corresponding switch cupboard.
installation.
accessories: taps, appliance cords, coatings, switch, extension cords, etc.
against burns of hot parts, projections and slag.
ii
Advertisement
Table of Contents
