Table of Contents
Advertisement
5.4
SC4 assembly without SCP4
Requirements: Mounting surface is level and clean.
NOTICE
Risk of damage to the mounting flange!
Unsuitable screw heads or too great a tightening torque for the screws
can damage the mounting flange.
Do not use countersunk screws.
4
Tighten screws with a maximum torque of 1.1 Nm.
4
The screw must not deform the mounting flange during tightening.
4
►
Place and position the SC4 (B), then install it with the recommended
screws. The screw head must not deform the mounting flange (B).
►
Place cover ring (A) with groove
(D) downward and press close
to the button surface. The cover
ring must be flush with the entire
button surface.
NOTICE
Mineral grease and oils can attack the plastic of the button!
Do not use grease or oils to apply the cover ring (A).
4
NOTICE
The SC4 is not short circuit-proof and can be damaged if connected
incorrectly.
Before applying the operating voltage, check to ensure correct
4
connection.
safeCAP SC4
safeCAP SC4 with
MCR-225
1.3
11/19
Advertisement
Table of Contents
