Prepare Sc4 For Assembly; Recommended Screw Types; Maximum Dimensions Of The Screws - Captron safeCAP SC4 Original Operating Instructions

5.1

Prepare SC4 for assembly

Requirements: Mounting surface is
level and clean.
► Disconnect the system from its
voltage supply and secure it
against being switched on again.
► Set the desired position of the
SC4 and provide a center hole of
minimum Ø 45 mm to maximum
Ø 60 mm.
► Position the SC4 (B), lining up
the center and vertical axis, and
mark the holes (C).
► Select the diameter of the holes
according to the recommended
screw type and start drilling.
► Depending on the installation
position, you now need
to connect the SC4.
"Connecting SC4 to the safety
relay"
5.2

Recommended screw types

DIN EN ISO 1207 M4
DIN EN ISO 7045 M4
DIN EN ISO 1481 Ø3.9 mm
DIN EN ISO 7049 Ø3.9 mm
5.3

Maximum dimensions of the screws

The drawing shows the maximum
dimensions of the screws.
10/19
see
1.3 safeCAP SC4
safeCAP SC4 with MCR-225