IBM IntelliStation M Pro Installation Manual page 38

10. Gently slide the drive tray into the drive cage until the tray snaps into place.
11. Determine whether the new drive is a SATA or SCSI device; then, connect one
12. Route the signal cable so that it does not block the airflow to the rear of the
13. Connect the power cable to the back of the drive. The connectors are keyed
14. Push the drive-cage retention latch toward the front of the computer; then,
15. If you have other options to install or remove, do so now; otherwise see
Power and signal cables for internal drives
Your computer uses cables to connect IDE, SATA, and SCSI devices to the power
supply and to the system board. (See "System-board internal connectors" on page
14 for the location of system-board connectors.) Review the following information
before connecting power and signal cables to internal drives:
26
IBM IntelliStation M Pro Types 6225 and 6228: Installation Guide
8. Attach the new drive to the drive tray. Place the drive on the drive tray and
align the holes on the drive with the mounting pins on the drive tray. Gently
pull both sides of the drive tray outward and insert the mounting pins into the
holes on the drive.
9. Align the drive assembly with the guide rails in the bay (make sure that the
connector end of the drive is facing you).
end of the applicable signal cable into the back of the drive and the other end
of this cable into the applicable SATA or mini-PCI SCSI connector. See "Power
and signal cables for internal drives" on page 26 for additional information
about cabling drives and "System-board option connectors" on page 13 for the
location of SATA and mini-PCI SCSI connectors on the system board. If there
are open connectors on the cables that connect existing SATA or SCSI drives,
these cables can be used to connect the new drive.
drives or over the microprocessor.
and can be inserted only one way.
rotate the drive cage back into the computer.
Note: As you rotate the drive cage, make sure the hard disk drive cables or
other internal cables do not impede the rotation of the drive cage.
"Completing the installation" on page 31.