Table of Contents
Advertisement
PACIFIC CORPORATION
2-23-3 EBISU-MINAMI SHIBUYA-KU TOKYO 150-0022 JAPAN
Cases for Indemnity (Limited Warranty)
11.
We shall be exempted from taking responsibility and held harmless for damage or losses incurred by the user
in the following cases.
In case damage or losses are caused by fire, earthquake, or other acts of God, acts by third party,
deliberate or accidental misuse by the user, or use under extreme operating conditions.
In case indirect, additional, consequential damages (loss of business interests, suspension of
business activities) are incurred as result of malfunction or non-function of the equipment,
we shall be exempted from responsibility for such damages.
In case damage or losses are caused by failure to observe the information contained in the
instructions in this product specification & operation manual.
In case damage or losses are caused by use contrary to the instructions in this product
specification & operation manual.
In case damage or losses are caused by malfunction or other problems resulting from use of
equipment or software that is not specified.
In case damage or losses are caused by repair or modification conducted by the customer or any
unauthorized third party (such as an unauthorized service representative).
Expenses we bear on this product shall be limited to the individual price of the product.
CMOS Pixel Defect
12.
Noticeable CMOS pixel defects (White Spot) found during our inspection process are compensated. On very
rare occasions, however, CMOS pixel defects might be noted with time of usage of the products.
The cause of the CMOS pixel defects is the characteristic phenomenon of CMOS itself and Pacific
Corporation are exempted from taking any responsibilities for them. Pixel defects (White Spot) compensation
we perform is not to guarantee its effects to whole white spot.
CMOS pixel defects (White Spot) may be seen when gain is increased by AGC or when slow shutter is used,
however, this shall not be considered as an inferior product.
Product Support
13.
When defects or malfunction of our products occur, and if you would like us to investigate on the cause and
repair, please contact your distributors you purchased from to consult and coordinate.
Camera control sample software (RS232C) is available. We shall be exempted from taking responsibility and
held harmless for damage or malfunction of your hardware and software caused by using this control software.
The purpose of this control software is for you to check operation and evaluate our products. Please be noted
that Pacific Corporation do not customize the program nor provide source code.
TEL: +81-3-3760-8881 FAX : +81-3-3760-8882
2010 Pacific Corporation.
17
Tokyo H.Q.
Advertisement
Table of Contents
