Table of Contents
Advertisement
pulled out of the frame (A) and removed from the
mounting plate (F). Grab the sides of the electronic
unit and pull it out (see figure 6). You do not need
to open the accessory.
2. Turn the electronic unit over to remove or insert the
batteries.
3. Insert two new 1.5 V LR03/micro/AAA batteries.
Make sure that you insert them the right way round
(see figure 7).
4. Put the electronic unit back into the frame. Make
sure that "TOP" and the arrows on the back side of
the electronic unit point upwards and that the clips
on the mounting plate latch into the openings on
the electronic unit.
5. Pay attention to the flashing signals of the LED
while inserting the batteries (see „9.3 Error codes
and flashing sequences" on page 29).
»
After inserting the batteries, the accessory will per-
form a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED will light up
orange and green to indicate that initialisation is
complete.
Attention! There is a risk of explosion if the battery
is not replaced correctly. Replace only with the
same or equivalent type. Never recharge non-
rechargeable batteries. Do not throw the batteries
into a fire. Do not expose batteries to excessive
Replacing batteries
25
Advertisement
Table of Contents
