Loewe REFERENCE 52 SL FHD+ 200 NMP Service Manual page 28

TECHNICAL CUSTOMER SERVICE
Fig. 25
Unscrew both the T20 Torx screws from the support plate of the basic board (see green arrows
on fig. 25).
5.2 Removal of the shielding plate of the controller board
Make a gap between the shielding plate and the crossbar by pushing the crossbar backwards
somewhat.
The 4 screws can now be removed from the shielding plate using a Phillips screwdriver.
The adhesive film must be removed from the shielding plate before the plate can be taken off.
Carefully loosen the adhesive strips from the plate and pull them upwards and off.
The film connections in the upper part of the module and the cable connections in the lower part
must then be removed.
The two bottom cable harnesses are covered by the crossbar and can be reached from the
bottom of the support after folding the basic board out of the way (see fig. 26 and fig. 27).
Fig. 26 Fig. 27
28
Loewe Opta GmbH
96317 Kronach, Industriestr. 11
96305 Kronach, Postfach 15 54
Telefon (0 92 61) 99-0
Telefax (0 92 61) 99-730
e-mail: loewe@loewe.de
www.loewe.de