Loewe REFERENCE 52 SL FHD+ 200 NMP Service Manual page 20

Fig. 1
1.2 Removal of the CI module and AVS socket board
To disassemble the signal board support, unscrew the three T20 Torx screws on the support
plate and two T10 Torx screws on the signal board.
The CI module and the AVS socket board must already have been removed to do this, since
one screw is covered by these modules.
The CI module is fixed with three T20 Torx screws and the AVS socket board with two T20 Torx
screws to the support plate (see fig. 3).
After removing the modules, observe the cabling and remove the connection to the signal
board.
Fig. 3
Fig. 2
20
Loewe Opta GmbH
96317 Kronach, Industriestr. 11
96305 Kronach, Postfach 15 54
Telefon (0 92 61) 99-0
Telefax (0 92 61) 99-730
e-mail: loewe@loewe.de
www.loewe.de