Siemens SiPass integrated Reference Manual page 29

A6V11144326
Source State (trigger)
Intrusion Control
Enabled
Invalid
Invalid Dual Custody An Invalid Dual Custody event has occurred.
No Entry
Operator Alarm
Operator Alarm
Actioned
Operator Alarm Not
Actioned
Operator Alarm
Timed out
Operator Normal
Operator Restore
Operator Waiting for
Normal
PIN Error Disabled
Reader Offline
Reader Online
Reader Tamper
SALTO Battery Low
SALTO PPD
Connection
SALTO System
Offline
SALTO System
Online
Host event tasks
Description
Intrusion Control has been enabled at the access
point.
A host event task is triggered when a point
enters any alarm state, assuming that an alarm
class has been configured for the access point.
A host event task is triggered if the access point
is set to "De-layed Reporting" mode and a valid
card has been badged at a reader, but the door
monitor has not registered passage through the
door.
A host event task is triggered when the
nominated access point goes into alarm.
A host event task is triggered, when an alarm
associated with the nominated access point, is
actioned by an operator.
A host event task is triggered when the operator
fails to action an alarm associated with the
nominated access point before the (re-activation)
timeout.
A host event task is triggered when the operator
fails to action the alarm associated with the
access point and the alarm time-out.
A host event task is triggered when the
nominated access point changes to a normal
state.
A host event task is triggered when the
nominated access point attains 'Restored' status.
A host event task is triggered when a restorable
alarm at the nominated point has been ac-tioned
but has not returned to its normal state.
A card has been voided after the cardholder has
made three consecutive incorrect PIN entries in
the facility.
A host event task is triggered when a reader
enters the offline state. Only valid for the
Siemens reader range.
A host event task is triggered when a reader
enters the online state. Only valid for the
Siemens reader range.
A host event task is triggered when a reader
enters the tamper state (tamper input activated).
Only valid for the Siemens reader range.
A SALTO offline door requires a battery change.
A PPD has been connected to a SALTO offline
door to update the door.
SiPass integrated is not connected to the SALTO
System.
SiPass integrated is connected to the SALTO
System.
7
Sources
29 | 66