Siemens SiPass integrated Reference Manual page 21

A6V11144326
Type Mode
Card and Pin
Access/Intrusion
Operational Modes
Description
This mode provides the option to
secure/unsecure the intrusion areas. In case the
cardholder wants to arm/disarm/part-arm the
area before a card is presented at the access
point, it can be done by selecting a number from
the reader keypad:
Press '0' then 'E' or '#' to disarm the area
●
Press '1' then 'E' or '#' to arm the area
●
Press '2' then 'E' or '#' to part-arm the area
●
Press '9' then 'E' or '#' OR Press just '*' to
●
cancel the current selection
After this, a card badge followed by a valid PIN
enables standard access and unlocks the door
(while performing the selected arming action).
Note:
The type of reader installed determines if
●
'E' or '#' is used as the enter key for
confirming the option selected by a card-
holder.
For the Card+PIN functionality, some card
●
readers provide the option to enter a PIN
first followed by a card badge. In this case,
the 'E' or '#' key is not required to be
pressed again after the PIN is entered, and
the users just present their card (previous
pressing of the E or # key for arming
selection has no effect on this). However, if
the card is badged first after selecting an
arming action, the 'E' or '#' key must be
pressed after entering the PIN.
For devices that do not require a button to be
pressed after entering the PIN:
Some devices (like DC12, DC22, DC800,
GrantaCotagCard and GrantaSwipeCard) do
not require a button to be pressed after entering
the PIN. For example, when entering a PIN at a
BC43 reader connected to such a device, the
user does not have 'E' or '#' or 'OK' button to
send the PIN.
If the card has been badged, the user can
●
enter the PIN di-rectly (which is
automatically processed).
If the card has not been badged, each key
●
is processed individually. In this case, the
user can press the respective key to
arm/disarm/part-arm the area, badge the
card and enter the PIN for authentication.
In both the above cases, the PIN is processed
automatically after the last key for the PIN is
pressed and the applicable action is performed.
Press '0' to disarm the area
●
Press '1' to arm the area
●
Press '2' to part-arm the area
●
Press '9' or 'A' or 'B' to cancel the current
●
selection
5
21 | 66