Pillow Speaker Setup; Connecting; Pillow Speaker Interface; Controlling With Mechanical Switches - LG 26LH1DC1 Installation And Operating Manual

EXTERNAL EQUIPMENT SETUP

PILLOW SPEAKER SETUP

Here shown may be somewhat different from your TV.
1. How to connect
Connect the PILLOW JACK IN the Pillow Speaker output
1
jack on the back of the TV.
Connect an accessory pillow speaker or wired remote
2
control unit to this 6-pin jack.
3
Select PILLOW SPEAKER on the rear panel of the TV.
*Note: If the pillow Speaker switch is set to Pillow Speaker, no sound will
be heard from the TV speakers. If pillow speaker switch is set to the
Pillow Speaker position, Auto Volume will be grayed out and not
accessible on the Sound menu.
Use a pillow speaker by Curbell, Model A-16455-02 or
other UL recognized pendant control bearing the warning:
"Risk of fire if used in oxygen enriched atmosphere.
Keep pendant control away from oxygen equipment."
Controlling the TV with Serial Data
The TV is capable of being controlled by a single-wire,
serial data signal. This is a LG patented technology and is
being implemented by certain brands of "smart" pillow
speakers, such as Curbell's "GEN-II" models.

Pillow Speaker Interface

This connector furnishes three control lines and an audio
output. A patient-pendant remote control, or entertainment
audio and nurse call system may be connected here. All
lines are isolated from the AC power line and earth ground.
(Optoisolators isolate the control lines, and a transformer
isolates the audio. There are no relays or inductive
components in the control lines.)
Pin No. Purpose
1 External TV On/Off switch.
2 (Not used.)
3 External Channel Up switch or Data in.
4 Common connection for control, data, and audio output.
Impedance to earth ground is a 10-meg resistor in parallel
with a 1 100 pf capacitor.
5 Isolated audio output. Nominal 14-ohm source impedance
with short circuit protection. Intended for a pillow speaker
with a low-impedance pad-type volume control.
6 External Channel Down switch.
22
Pillow speaker not included with TV.
Controlling the TV with Mechanical Switches
Pin 4 (common) is momentarily connected to pin 1,
3, or 6 via push-action switches to control On/Off
and Channel Up/Down. These pins are at +13 volts
DC (when measured from pin 4) with the switches
open. Current draw is 8 mA when a switch is
closed. (This operation is identical to previous LG
models using the 5-Wire Interface except that only
+7 volts DC was supplied and current draw was
only 2.5 mA.)