Clone Troubleshooting - LG 26LH1DC1 Installation And Operating Manual

APPENDIX
CLONING PROCEDURE TROUBLESHOOTING
IMPORTANT INSTALLER SETUP INFORMATION! PLEASE READ THE FOLLOWING...
Warning: Do not use LT2002 while a
LodgeNet PPV card is installed in TV or clone
programmer will be damaged.
Reset Clone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, activate the
internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may
be necessary to reset the Clone Programmer clock from
a TV containing the correct time.
Remote does not operate clone.
Wrong Installer remote.
LED does not blink
M.P.I. cord not connected.
26LH1DC1 not turned on.
Weak batteries.
Clone menu hard to read.
Weak signal.
No time set.
Time not available.
74
Only use an appropriate Installer remote to operate clone programmer with 26LH1DC1.
8
Connect M.P.I. cord.
8
26LH1DC1 must be powered On for clone to work.
8
Install 4 fresh AA high-quality alkaline batteries.
8
Connect 26LH1DC1 to a reliable Analog channel signal source.
8
Set time on a TV, copy time to Clone Programmer.
8
*Note: The LT2002 programmer is designed to be used with TVs
con-tain-ing the 221-01006 and later processors. Use with earlier
TV sets may give unpredictable results. Processors used before the
221-01006-04 have a limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use the
printed menu illustrations on the quick setup sheet supplied with the
Clone as an aid to making your programming choices. (Although the
menus are not all displayed, the clone functions all operate normally.)