Maintenance And Troubleshooting - NordicTrack COMMERCIAL X 22 i User Manual

MAINTENANCE AND TROUBLESHOOTING

MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and prop-
erly tighten all parts each time the incline trainer is
used. Replace any worn parts immediately. Use only
manufacturer-supplied parts.
Regularly clean the incline trainer and keep the walking
belt clean and dry. First, press the power switch into
the off position and unplug the power cord. Wipe
exterior parts of the incline trainer with a damp cloth
and a small amount of mild soap. IMPORTANT: Do
not spray liquids directly onto the incline trainer.
To avoid damage to the console, keep liquids away
from the console. Then, thoroughly dry the incline
trainer with a soft towel.
TROUBLESHOOTING
Most incline trainer problems can be solved by fol-
lowing the simple steps below. Find the symptom
that applies, and follow the steps listed. If further
assistance is needed, see the front cover of this
manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see
page 13). Use only a surge suppressor that meets
all of the specifications described on page 13.
IMPORTANT: If the incline trainer is connected
to an AFCI-equipped outlet and your circuit
breaker trips repeatedly when the incline trainer
is used, see the front cover of this manual to
purchase an arc filter.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the incline
trainer frame near the power cord. If the switch
protrudes as shown (A), the switch has tripped. To
reset the power switch, wait for five minutes and
then press the switch back in (B).
c
A
All manuals and user guides at all-guides.com
SYMPTOM: The power turns off during use
a. Check the power switch (see drawing c at the left).
b. Make sure that the power cord is plugged in. If the
c. Remove the key from the console, and then
d. If the incline trainer still will not run, please see the
SYMPTOM: The incline of the incline trainer does
not change correctly
a. Calibrate the incline system (see step 6 on
SYMPTOM: The walking belt does not run
If the console does not function properly, see page 29.
If the console displays time and distance while a work-
out is running, but the walking belt does not move, do
the following:
a. Turn off the power (see page 15) and unplug the
b. Wait for a minimum of five minutes to make sure
c. Plug in the power cord (see page 13), turn on the
d. If the walking belt still does not run, please see the
B
27
If the switch has tripped, wait for five minutes and
then press the switch back in.
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
reinsert it.
front cover of this manual.
page 23).
power cord.
that any residual charge has dissipated from the
incline trainer's electronics.
power, and start the walking belt again.
front cover of this manual.