Honda EU65is Owner's Manual page 76

Hanger Kit
Protect the fuel tank and frame pipe with the protector films during
installation of the hanger.
1. Insert the bracket installation part at one end of the hanger into the
clearance between the frame pipe and fuel tank.
2. Slide the hanger and insert another bracket installation part of the
hanger into the gap between the frame pipe and fuel tank on the
other side.
3. Slide the hanger along the frame pipe to align the center of the
hanger with the recessed part on the rear side of the fuel tank.
Install the hanger brackets on both ends of the hanger and tighten
the 8 × 16 mm flange bolts securely.
TORQUE: 24 29 N·m (2.4 3.0 kgf·m , 17 22 lbf·ft) −
HANGER
−
HANGER
PROTECTOR FILM
−
8 16 mm FLANGE BOLT (4) ×
HANGER
BRACKET (2)
73