Other Function
Sleep Timer Setting
You can set the DVD/CD receiver to turn off automati-
cally at a specified time.
Press SLEEP to set the desired sleep time.
1 1
The SLEEP indicator and sleep time appears in the dis-
play window.
Each time you press SLEEP the setting changes
2 2
in the following order.
SLEEP 90 →80 → 70 → 60→ 50 → 40 → 30 → 20 →10 →
OFF
ote
You can check the time remaining before the
DVD/CD receiver turns off.
Press SLEEP. The remaining time appears in the
display window.
Dimmer
This function will change the brightness of the display
window on the front panel during in power-on status.
Press the DIMMER repeatedly.
Mute
Press MUTE to mute your unit.
You can mute your unit in order, for example, to answer
the telephone, "MUTE" indicator flashes in the display
window.
Using Headphone Jack
Connect a stereo headphone plug ( 3.5mm) into the
PHONES connector.
The speakers are automatically disconnected when you
plug in a headphone (not supplied).
Selecting input source
You can use VCRs or other units connected to the
VIDEO1, VIDEO2 connectors or Optical connector.
Refer to the owner's manual supplied with the unit for
further information on the operation.
Press AUX repeatedly on the remote control to
select the desired input source.
Each time you press this button, the mode of the func-
tion changes in the following sequence:
VIDEO 1: for selecting the analog signal from VIDEO1
AUDIO IN (L/R) & VIDEO IN Connectors.
VIDEO 1 OPT: for selecting the digital signal from VIDEO 1
OPTICAL IN Connector.
VIDEO 2: for selecting the analog signal from VIDEO2
AUDIO IN (L/R) & VIDEO IN Connectors.
VIDEO2 OPT: for selecting the digital signal from VIDEO 2
OPTICAL IN Connector.
otes
The Optical input function is available only when the
other unit's Sampling Frequency is 32 ~ 96kHz.
You can also select the input source by pressing
PLAY/FUNCTION button on the front panel.
Press and hold down this button about 3 seconds,
then press repeatedly to select input source.
31