SECTION 1. GENERAL PART ❏ SERVICING PRECAUTIONS NOTES REGARDING HANDLING OF THE PICK-UP 1. Notes for transport and storage 1) The pick-up should always be left in its conductive bag until immediately prior to use. 2) The pick-up should never be subjected to external pressure or impact. Storage in conductive bag Drop impact 2.
Page 4
NOTES REGARDING COMPACT DISC PLAYER REPAIRS 1. Preparations 1) Compact disc players incorporate a great many ICs as well as the pick-up (laser diode). These components are sensitive to, and easily affected by, static electricity. If such static electricity is high voltage, components can be damaged, and for that reason components should be handled with care.
❏ ESD PRECAUTIONS Electrostatically Sensitive Devices (ESD) Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Electrostatically Sensitive Devices (ESD). Examples of typical ESD devices are integrated circuits and some field-effect transistors and semiconductor chip components. The following techniques should be used to help reduce the incidence of component damage caused by static electricity.
Page 13
• POWER SCHEMATIC DIAGRAM NOTE: Warning NOTE: Parts that are shaded are critical With respect 1. Shaded(I) parts are critical for safety.Replace only to risk of fire or electrical shock. with specified part number. 2. Voltages are DC-measured with a digital voltmefer during Play mode.
❏ VOLTAGE SHEET (IC&TR) LOC. PART PIN NUM. STOP DVD PLAY LOC. PART PIN NUM. STOP DVD PLAY LOC. PART PIN NUM. STOP DVD PLAY -15.1 -15.2 IC500 KIA7808 11.9 11.9 IC650 LC8767XX -26.7 -26.7 -26.7 IC501 KIA7812 18.4 18.4 4.54 4.54 -17.7...
Page 16
LOC. PART PIN NUM. STOP DVD PLAY LOC. PART PIN NUM. STOP DVD PLAY -4.5 -4.5 IC400 TDA7265 -18.7 -18.7 18.6 18.6 -18.6 -18.6 IC450 KIA4558 IC601 M60446AFP -5.3 -5.3 IC200 TDA7265 -18.7 -18.7 18.6 18.6 -18.6 -18.6 IC250 TDA7265 -18.7 -18.7 18.6...
❏ DETAILS AND WAVEFORMS ON SYSTEM TEST AND DEBUGGING 1. SYSTEM 27MHz CLOCK,RESET,FLASH R/W SIGNAL 1) MT1379 main clock is at 27MHz(X501) 2) MT1336 reset is high active - 3-9 -...
Page 29
3) RS232 waveform during procedure(Downloading) 4) Flash R/W enable signal during download(Downloading) - 3-10 -...
Page 30
2. SDRAM CLOCK 1) MT1379 main clock is at 27MHz(X501) 3. TRAY OPEN/CLOSE SIGNAL 1) Tray open/close waveform - 3-11 -...
Page 31
2) Tray close waveform 3) Tray open waveform - 3-12 -...
Page 32
4. SLED CONTROL RELATED SIGNAL (NO DISC CONDITION) 5. LENS CONTROL RELATED SIGNAL(NO DISC CONDITION) - 3-13 -...
Page 33
6. LASER POWER CONTROL RELATED SIGNAL (NO DISC CONDITION) 7. DISC TYPE JUDGEMENT WAVEFORM - 3-14 -...
SECTION 4. EXPLODED VIEWS • CABINET AND MAIN FRAME SECTION NOTE) Refer to “SECTION 6 REPLACEMENT PARTS LIST” in order to look for the part number of each part.