Advertisement
Image 1
1. Select a location that allows the concentrator unit to draw in room air
without being restricted. Make sure that the unit is at least 4 inches
(10cm) away from any wall, furniture, or curtains that could impede
adequate airflow. Do not place the unit near any heat source.
2. Plug the power cord into an electrical outlet.
3. Connect the provided silicon tubing to port at top right rear of the
machine as shown in Image 1.
4. Press the power switch to the ON [I] position. The LED display screen will
illuminate.
5. Press the ON/OFF power button once to turn the unit on. The oxygen will
begin flowing from the unit immediately.
6. Adjust the flow by turning the knob on the top of the flow meter until the
ball is centered at 10. See Image 3 for knob reference.
7. When the oxygen concentrator is not in use, press the power switch to
the OFF [O] position.
davincimedicalusa.com
6
CONTROL PANEL
Image 2
Image 3
Advertisement
