Advertisement
Before you style your hair:
1 Slide a suitable attachment onto the handle ( ) and turn the
ring ( ) to lock it ( ).
•
To disconnect the attachment, unlock it ( ) and pull it off.
2 Slide a suitable styler or crimping/straightening plates onto the
attachment.
3 Place the appliance with the support ( ) outwards on a heat-
resistant surface.
4 Connect the plug to a power supply socket.
5 Slide the on/off switch ( ) to I to switch on the appliance.
» The power-on indicator ( ) lights up.
» When the appliance is ready for use, the ready indicator ( )
changes color from red to dark.
6 Comb your hair and divide your hair into small sections that are
not wider than 5-6cm.
7 Move the support ( ) backwards.
Create curls or ringlets
1 Press the lever ( ) to open the clip ( ) and place a section of
hair between the clip and barrel ( ).
2 Release the lever and slide the barrel to the hair tip.
3 Hold the cool tip ( ) and the handle, and then wind the section
of hair round the barrel from end to root.
4 Hold the barrel in the position for max. 15 seconds, and then
unwind the section of hair until you can open the clip again with
the lever or until you can remove the spiral from your hair.
5 To style the rest of your hair, repeat steps 1 to 4.
Create crimps
1 Press the lever ( ) to open the attachment and place a section
of hair between the crimping plates. Start crimping at the roots.
Advertisement
