Table of Contents
Advertisement
6.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Press
▶
a The fan run-on starts at fan setting 1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
6.7 Switching off the fan run-on
Press
▶
6.8 Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
Press .
▶
6.9 Switching off automatic mode
Press , or .
▶
a The ventilation is automatically ended when the
sensor detects no further change in the room air
quality.
a Automatic mode runs for a maximum of four hours.
6.10 Sensor control
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting: 3
¡ Lowest setting: 1
¡ Highest setting: 5
6.11 Setting the sensor control
Requirement: The appliance is switched off.
Press and hold .
1.
a The setting is displayed after approx. one second.
Press , , ,
or
2.
Release to save the setting.
3.
6.12 Resetting the saturation
indicator_variant 1
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
appears on the display for the grease filter.
¡ After the appliance has been switched off,
appears on the display for the odour filter.
1
Depending on the appliance specifications
1
1
1
to change the setting.
and 1
and 2
Press
.
▶
a The saturation indicator is reset.
6.13 Resetting the saturation
indicator_variant 2
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
appears on the display for the grease filter.
¡ After the appliance has been switched off,
appears on the display for the odour filter.
To reset the saturation indicator for the grease filter,
1.
press
.
To reset the saturation indicator for the odour filter,
2.
press
.
a The saturation indicator is reset.
6.14 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
Press and hold
1.
To set circulating-air mode (non-regenerative fil-
‒
ter), press .
To set circulating-air mode (regenerative filter),
‒
press .
To set air extraction mode, press .
‒
Release
to save the setting.
2.
6.15 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press
.
▶
6.16 Setting the brightness
Press and hold
until the required brightness is
▶
reached.
6.17 Switching on the audible signal
Requirement: The appliance is switched off.
Press and hold
and
▶
prox. three seconds until a signal sounds.
6.18 Switching off the signal tone
Requirement: The appliance is switched off.
Press and hold
and
▶
prox. 3 seconds.
a A signal tone will sound.
Basic operation en
.
at the same time for ap-
at the same time for ap-
and 1
and 1
7
Advertisement
Table of Contents
