Table of Contents
Advertisement
Installing the appliance bracket
Screw on the angle bracket for the flue duct.
1.
Screw on the brackets for the appliance until they
2.
are hand-tight.
Do not firmly tighten the screws.
Screw in the threaded pin, leaving it protruding out
3.
of the wall by 5–9 mm.
Installing the appliance
First remove the protective film from the back of the
1.
appliance and, following installation, remove the rest
of the film.
When mounting the appliance, ensure that it en-
2.
gages properly with the mounting supports.
To align the appliance horizontally, turn the mount-
3.
ing brackets.
If required, move the appliance to the right or to the
left.
Firmly tighten the screws for the mounting brackets,
4.
holding the mounting brackets in place.
Firmly tighten the knurled nuts.
5.
Piping
Note: If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend the piping with an exhaust air pipe dia-
meter of 150 mm.
Establishing the exhaust air connection (exhaust air
pipe, 150 mm diameter)
Fit the exhaust air pipe directly to the air-pipe con-
▶
nector and seal the joint.
Establishing the exhaust air connection (exhaust air
pipe, 120 mm diameter)
Secure the reducing connector to the air-pipe con-
1.
nector.
Secure the exhaust air pipe to the reducing con-
2.
nector.
Seal the joints.
3.
Installing the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
WARNING ‒ Risk of electric shock!
Sharp-edged components inside the appliance may
damage the connecting cable.
Do not kink or trap the connecting cable.
▶
Screw the retaining bracket for the flue duct to the
1.
wall.
Installation instructions en
15
Advertisement
Table of Contents
