Table of Contents
Advertisement
Automatic malfunction bypass
To provide the utmost protection even if a system component malfunctions, your
IntelliGuard 700 will automatically bypass any faulty point and arm all other triggers and
sensors until you can have the system serviced by your local Authorized Dealer.
Multiple-event TotalRecall™
The system's non-volatile memory records the identity of the last eight activated or
malfunctioning triggers and/or sensors, which allows your installer to instantly track down
malfunctions and save you substantial servicing costs. To identify the triggers and/or sensors
held in the system's non-volatile memory, simply perform the following procedure:
1. With the ignition OFF, flick the PlainView valet switch to its latched side.
2. Press button I to "arm" the system, then again to "disarm."
3. The LED will blink 1–5 times to indicate the most recently activated trigger or
sensor, pause, then blink 1–5 times to indicate the next most recently activated
trigger or sensor, and so on for the last 8 activations.
4. Write down the number of blinks between pauses and refer to the chart below:
Number of LED blinks per cycle
1 blink
2 blinks
3 blinks
4 blinks
5 blinks
Smart prior intrusion attempt alert
When you remotely disarm, if you hear three chirps and see three parking light flashes
(instead of the usual one and one) it means that a trigger or sensor was activated in your
absence. When you enter the vehicle and turn on the ignition (or start the engine), the
LED will blink 1–5 times, pause, then repeat the blink cycle 4 more times. Count the
number of blinks in one cycle and refer to the chart below:
Number of LED blinks per cycle
1 blink
2 blinks
3 blinks
4 blinks
5 blinks
Trigger/sensor that was activated or malfunctioned
Magnetic Resonance Sensor
Optional sensor
Door trigger
Trunk trigger
Hood trigger
Trigger/sensor that detected the intrusion attempt
Magnetic Resonance Sensor
Optional sensor
Door trigger
Trunk trigger
Hood trigger
16
Advertisement
Table of Contents
