LG LRM2060ST Installation Instructions page 2

4
1. Fold or cut the front edge of the template,
along the front guide line. Place the template
flush along the front edge of the cutout floor,
aligning the center line of the template with the
center line of the cutout floor. Mark the center
positions with an awl or center punch for the
anti-tip bracket location as shown.
2. Remove the template and drill two holes for
the anti-tip bracket.
1 2 " Screws (2)
3. Install the anti-tip bracket onto the cutout
floor using two / " screws.
1
2
Cutout Floor
Anti-Tip Bracket
2
5
1. Remove the one existing screw from the left side
of the microwave oven.
2. Connect the side duct to the upper duct as
shown.
a) Insert projecting tabs of the upper duct into
the holes of the side duct.
b) Bend the tabs up as shown.
NOTE: Remove any oil or dirt on the surface of
the microwave oven before the ducts are attached.
Upper Duct
3 Tabs
a)
3. Peel off the backing of the double sided tape.
Attach the side duct and upper duct assembly
on the microwave cabinet. Press down firmly
on the ducts. Fasten the duct assembly to the
left side of the cabinet with one existing screw.
Existing Screw (1)
Side Duct
3 Holes
b)