Cleaning And Care - Electrolux EFP 4200 Manual

g
0 After using, turn cover clockwise
and remove.
Only remove the cover when the
1
tool has come to a complete stop!
0 Remove the tool and spindle.
0 Turn the all-purpose bowl clock-
wise and remove.
Citrus press
(depending on model)
Preparation (fig. 13)
0 Fit all-purpose bowl as described
above (fig. 5).
0 Place sieve insert of citrus press
(fig. 13/a) on all-purpose bowl
(mark on mark
cunter-clockwise to the stop. The
sieve insert can be heard to
engage (mark
0 Insert press cone (fig. 13/b) in
sieve insert.
Operating citrus press
0 Start appliance: turn speed selec-
tor (fig. 1/I) right to position 1.
The citrus press must only be
3
operated at the lowest speed.
0 Switch off appliance: turn speed
selector left to the "0" position.
0 Remove press cone after use.
0 Turn sieve insert clockwise and
remove.
0 Turn all-purpose bowl clockwise
and remove.
The appliance can be used for up
1
to 10 minutes without stopping. It
should be allowed to cool each
time following prolonged, continu-
ous operation (for at least
20 minutes after using for
10 minutes without stopping).
46
www.preciz.hu

Cleaning and care

Motor casing
Mixer
) and turn
on mark ).
1 Ensure that no liquid enters the
motor casing!
0 Clean the motor casing with a
moist cloth. Never immerse in
water or hold under running
water!
(depending on model)
3 Container and blade can be
cleaned easily and properly with
the aid of the pulse position.
0 Fill the mix container half full with
warm (not hot!) water and add a
few drops of detergent.
0 Press the pulse button briefly.
0 Then rinse the container under run-
ning water.
Dismantle/fit blade unit
(fig. 14)
If necessary, the blade unit can
3
also be dismantled and cleaned
separately.
1 Caution: The blade is very sharp!
Danger of injury!
0 Release blade unit (fig. 14/a) from
mix container using the closing
cover (fig. 1/D and fig. 14/c) as
tool. The grooves of the closing
cover fit the ribs of the blade unit.
Turn counter-clockwise and
remove while holding slightly at an
angle.
0 Remove gasket (fig. 14/b) from
blade unit.
The blade unit is very sharp. The
1
gasket can be damaged.
Rinse the components carefully by
1
hand (danger of injury!). Use only
water and detergent for cleaning.
Do not clean the blade unit in a
dishwasher.