Electrolux EFP 4200 Manual page 43

depending on the purpose of
application (see "Inserting cutting
insert in insert holder").
0 Place desired tool on spindle.
– Whisking disk, metal blade and
plastic blade (fig. 8) mesh with
the teeth underneath on the
spindle.
– The insert holder (fig. 11) rests
on the hexagonal spindle.
Preferably hold the insert holder
3
with two fingers in the two handle
holes.
Fitting the cover (fig. 6)
– The red warning lamp (fig 4/a)
flashes.
0 Place cover (fig. 1/F) on the all-pur-
pose bowl (mark
and turn counter-clockwise to the
stop. The cover can be heard to
engage. The nose of the cover is
then directly above the handle
(mark on mark
– The red warning lamp (fig. 4/a)
extinguishes.
0 Insert stopper (fig. 1/E) in filling
inlet.
Inserting cutting insert in
insert holder (fig. 10)
The appropriate insert must be
placed in the insert holder depend-
ing on use.
3 The inserts are contained in the
hinged accessories compartment
(fig. 1/K) in the motor casing.
1 The inserts are very sharp. They
should be held only with the
handle!
0 Open accessories compartment by
pulling the handle (fig. 9).
0 Take required insert by the handle
from the accessories compartment
(fig. 9).
www.preciz.hu
0 Place the insert with the tip at the
0 To remove the insert draw slightly
Operating multifunction
section
0 Open cover (fig. 1/F) and place all
on mark )
3
).
1
0 Start the appliance: turn speed
3
1
0 Switch off appliance: turn speed
centre of the insert holder and
place in the recess of the disk
(fig. 10).
outwards with the handle and
raise.
(depending on model)
ingredients required in the all-pur-
pose bowl.
Caution: Do not exceed maxi-
mum filling volume:
– liquid 1.75 litres
– solid 1.5 litres
Further ingredients can be added
during operation through the filling
inlet. The filling beaker in the stop-
per (fig. 1/E) can also be used for
this purpose. Close the filling inlet
immediately each time to avoid
splashes.
Use the stopper exclusively to
compress the cutting items!
selector (fig. 1/l) right to the
desired speed setting or press the
pulse button (fig. 1/J).
It is recommended to start at a
slow speed and then to increase
the speed. The appliance oper-
ates at maximum speed by press-
ing the pulse button.
Refer to the section "Tips on using
multifunction section" for reference
values.
If the warning lamp (fig. 4/a)
flashes and the appliance cannot
be started, the safety cover for the
mixer drive (figs. 1/T and 4) is not
properly fitted.
selector left to the "0" position.
g
45