A-Tach # 50377
Designed for: Audi Q5 2009 - 2017
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the seam between the vent
openers and the silver vent trim illustrated with the
arrow in the photo.
(3) Press upward on the mount to flex the thin
lower edge of the mount into the lower seam. Use
the seam tool if needed to open the seam a little.
STL-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) Remove the covering from the tape. Press the
thin top edge of the mount into the top seam. Use
the seam tool if needed to open the seam a little.
(4) Press the upper and lower edges of the mount
all the way into the seams. The tape will not leave
any residue if the mount is removed in the future.
A-Tach
Mounts