A-Tach Mounts 50322 Quick Start Manual

A-Tach # 50322
Designed for: Volkswagen Taos 2022 - 20__
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
upper edge of the mount will attach into the seam
between the frame around the display and the dash
panel covering the display illustrated with the
arrows in the photo.
(3) Use the seam tool if needed to open the lower
seam a little.
See additional instructions on the back side.
ST-1
NOTICE: A-Tach Mounts
any damage to the vehicle or product due to the
installation and/or use of the product. The product has
been tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible to determine if you have the
skill to attach the product without causing damage
to your vehicle or the product.
Read all instructions and view the photos before
attaching this product.
(2) The lower edge of the mount will attach into
the seam between the frame around the vents and
the separating dash panel above the vents
illustrated with the arrows in the photo.
(4) Remove the covering from the tape. Then
press the thin lower edge of the mount into the
lower seam. The lower side of the mount is longer.
A-Tach
Mounts
will not be responsible for