A-Tach Mounts ST-1 Instructions

A-Tach # 50041
Designed for: Honda Civic Hatchback 2016-20__
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
lower edge of the mount will attach onto the panel
under the left center vent frame and behind the
display illustrated with the arrow in the photo.
(3) Remove the covering from the tape. Place the
lower edge of the mount under the dash panel
illustrated in the photo above.
See additional instructions on the back side.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) The top edge of the mount will attach into the
seam between the padded dash top and the dash
frame above the vent. See arrow in photo above.
(4) Using some pressure, press the mount to the
right until about half of the mount is behind the
display panel. It will be quite tight but it will go in.
A-Tach
Mounts