A-Tach Mounts 50232 Instructions

A-Tach # 50232
Designed for: Honda Fit 2015-20__
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING: AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
front of the mount will attach into the seam
illustrated with the arrow in the photo.
NOTE: This is a very tight seam.
(3) Press the seam tool into the seam. This will help
to open the seam for the mount to go into. NOTE:
The mount will only attach onto the area just
to the left of the vent center.
See additional instructions on the back side.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) The lower edge of the mount will attach into
the seam illustrated with the arrow in the photo.
(4) Remove the covering from the tape. Press the
front edge of the mount all the way into the seam.
NOTE: The edge of the mount will not go into
the seam in any other place.
A-Tach
Mounts