Typical Installation - Graco Dyna-Star 247540 Instructions, Repair And Parts

Installation

Typical Installation

The installation shown in F
Some of the equipment is required, as noted in the key. For assistance in designing a system to suit your needs, con-
tact your Graco distributor.
Mount pump securely so it cannot move during operation.
C
F . 2
IG
Key:
A Follower plate
B Weep tube
C Fluid outlet line (to gun)
D Drain valve (required)
E Ground wire
F Hydraulic return line, minimum 3/4 inch I.D. (required)
G Hydraulic outlet, 3/4" npt (f)
H Return line shut-off valve, minimum 3/4 inch (required)
J Hydraulic inlet, 3/4" npt (m)
K Tee, 3/4" npt
L Supply line shut-off valve (required)
*Included in Hydraulic Fluid Control Kit 247538 or 247705, which can be ordered separately.
6
. 2 is only a guide for selecting and installing system components and accessories.
IG
H
F
G
E
D
B
A
M
K
N
L
J
P
Q
R
M *Pressure gauge
N *Pressure reducing valve (required in systems over 600
psi [4.1 MPa, 41 bar])
P Accumulator
Q *Flow control valve (required in systems over 3 gpm [11
lpm])
R Hydraulic supply line
S Check valve
T Variable volume pressure compensated pump
U Hydraulic power supply
V Drain line, accumulator
U
T
S
ti0477a
312350L