Notes And Cautions - Samsung POWERbot SR1AM70 Series User Manual

Notes and cautions

Charging
Notes
If the battery overheats during charging,
it may take longer to charge.
If automatic charging is not working, do
the following:
– Turn the emergency switch (on the bottom
of POWERbot) off and on again.
– Unplug the docking station's power plug
and then plug it back on.
– Unplug the docking station, and then check
whether there is any foreign matter on
the charging pins. If there is, clean the
POWERbot and the charging pins of the
docking station with a dry cloth or rag.
– Check for any obstacles such as reflective
objects, chairs, etc. near the docking station.
If the POWERbot is left detached from the
docking station, the battery will drain.
– Try to keep the POWERbot in the docking
station so it can charge continuously when
not in use. However, you should turn off the
emergency switch and leave the docking
station unplugged if you plan to be out of
your house for long periods of time such as
when you go on vacation, etc.
Using
Notes
The POWERbot may get caught on
thresholds, etc. during cleaning.
– To restart operation, shut off the emergency
switch, move the POWERbot to an area
where it can move easily, and then turn on
the power again.
The POWERbot cannot completely clean
areas it cannot enter, such as corners,
between the wall and sofa, etc.
– Please use another cleaning tool to clean
them regularly.
The POWERbot cannot vacuum clumps
of dirt, so some may remain on the floor
after cleaning.
– Please use another cleaning tool to clean
them regularly.
If POWERbot is turned off, you cannot
turn it on by pressing the Power button
on the remote controller. Press and hold
the [Start/Stop] button on POWERbot.
You cannot select and have the POWERbot
execute Spot clean mode while it is
charging.
If you press the Manual clean / Point
cleaning button while the POWERbot is
charging, the POWERbot will detach itself
from the docking station and then go into
standby mode.
Cleaning and maintenance
Notes
If you washed the dustbin and filter with
water
– Dustbin: Completely wipe out the water.
– Filter: Completely dry it in the shade before
using.
When cleaning the auto shutter tool, do
not pull the auto shutter tool out too hard.
Caution
Watch your fingers when attaching or
detaching the filter, since they may get
stuck in the dustbin's intake.
To avoid blockages by foreign matter,
do not let the POWERbot vacuum up
toothpicks, cotton swabs etc.
If it is difficult to remove foreign matter
from the brush, contact an authorized
Samsung service center.
ENGLISH-32