Do you have a question about the HDP10000 Series and is the answer not in the manual?
Questions and answers
Yeasin khan
February 3, 2025
its not shwing actual voltage
1 comments:
Mr. Anderson
February 10, 2025
The Hantek HDP10000 Series may not be showing the actual voltage due to several possible reasons:
1. Load Regulation Issues: If the load regulation is not stable (≤0.1% + 5mV), it may cause voltage deviations. 2. Linear Regulation Variations: Small fluctuations in input voltage can affect the output voltage (≤0.01% + 5mV). 3. Readback Accuracy: The displayed voltage has an accuracy of ≤0.1% + 1 digit, which may cause slight deviations from the actual output. 4. Overvoltage Protection (OVP): If OVP is triggered, the output may be limited or shut off. 5. Ripple and Noise: The ripple voltage (10-15mVrms) can cause minor variations in the displayed value. 6. Instrument Warm-Up: The manual specifies that stable operation is achieved after 30 minutes of use within 18℃ to 28℃.
Checking these factors can help determine why the actual voltage is not being displayed correctly.
Need help?
Do you have a question about the HDP10000 Series and is the answer not in the manual?
Questions and answers
its not shwing actual voltage
The Hantek HDP10000 Series may not be showing the actual voltage due to several possible reasons:
1. Load Regulation Issues: If the load regulation is not stable (≤0.1% + 5mV), it may cause voltage deviations.
2. Linear Regulation Variations: Small fluctuations in input voltage can affect the output voltage (≤0.01% + 5mV).
3. Readback Accuracy: The displayed voltage has an accuracy of ≤0.1% + 1 digit, which may cause slight deviations from the actual output.
4. Overvoltage Protection (OVP): If OVP is triggered, the output may be limited or shut off.
5. Ripple and Noise: The ripple voltage (10-15mVrms) can cause minor variations in the displayed value.
6. Instrument Warm-Up: The manual specifies that stable operation is achieved after 30 minutes of use within 18℃ to 28℃.
Checking these factors can help determine why the actual voltage is not being displayed correctly.
This answer is automatically generated