Summary of Contents for Whalen Furniture Golden Oak Zeta ZT3060BK
Page 1
LOT NUMBER: DATE PURCHASED: Zeta 30 x 60 Bookcase Model # ZT3060BK ADULT ASSEMBLY REQUIRED DUE TO THE PRESENCE OF SMALL PARTS, SHARP POINTS, SHARP EDGES AS RECEIVED If you have any questions regarding assembly or parts are missing, DO NOT return this item to the store where it was purchased.
Model #ZT3060BK M A X I M U M R E C O M M E N D E D W E I G H T L O A D S MANUFACTURER: Golden Oak Furniture CATALOG: Zeta 30 x 60 Bookcase (ZT3060BK) DATE OF MANUFACTURE: September 2011 MADE IN CHINA THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE...
Page 3
Model #ZT3060BK Parts and Hardware List Please read completely through the instructions and verify that all parts listed are present before beginning assembly. A- Top Shelf Frame (1) B- Middle Shelf Frame (1) C- Bottom Shelf Frame (1) D- Lower Spine (1) E- Upper Spine (1) F- Left Lower Leg (1) G- Left Upper Leg (1)
Page 4
Model #ZT3060BK Parts and Hardware List Please read completely through the instructions and verify that all parts listed are present before beginning assembly. M- Middle Glass Shelf (1) N- Middle Lower Glass Shelf (1) O- Bottom Glass Shelf (1) (1) Suction Cup (2) Ø1/4”...
Page 5
Model #ZT3060BK Assembly Instructions Note: Please do not fully tighten all bolts until you finish assembling the frame. Once assembled, go back and fully tighten all bolts. This will make it easier during assembly of unit. 1. Unpack the unit and confirm that you have all the hardware and required parts listed. 2.
Page 6
Model #ZT3060BK Assembly Instructions 4. Align and attach 3 Self Frames (A, B and C) to the assembled Spine (D and E) using 35 mm Bolts (3) with Washers (4 and 5). Make sure the flat surface of the Shelf Frames will face up after assembly.
Page 7
Model #ZT3060BK Assembly Instructions 7. Pick up Right Leg assembly and align the back inserted nuts with the end brackets on three Shelf Frames (A, B and C) simultaneously. Insert and screw the 20 mm Bolts (2) with Washers (4 and 5) through the end brackets into the Legs. DO NOT tighten the bolts.
Page 8
Model #ZT3060BK Assembly Instructions 9. Stand the unit uprigh. Now go back and fully tighten all bolts. 10. Put the Suction Cups (1) firmly into the top holes of three Shelf Frames (A, B and C) and attach the Glass Clamps (7) to the threaded inserts on the back of Legs (F, G, H and I) and Spines (D and E).
Page 9
Model #ZT3060BK Assembly Instructions 12. Position the assembled unit at your desired location against a wall. If necessary, rotate the Floor Levelers pre-attached at the bottom of both Lower Legs (F and H) to level the unit. 13. Now follow the instructions printed on the plastic bag containing the Tipping Restraint Hardware to mount the tipping restraint to Upper Spine (E) and the wall.
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Use of furniture polish is not necessary. Should you choose to use polish, test first in an inconspicuous area. Using solvents of any kind on your furniture may damage your furniture’s finish. ...
Need help?
Do you have a question about the Golden Oak Zeta ZT3060BK and is the answer not in the manual?
Questions and answers