Safety Precautions; Technical Specification - Champion CHGF220 User Manual

Safety precautions

Read all safety warnings and all instructions. Failure to follow the warnings and instructions listed
below may result in electric shock, fire and/or serious injury.
EN
Warning: When using electrical appliances, basics safety precautions, including the following,
should always be followed to reduce the risk of fire, electric shock, personal injury and material
damage.
1. Read and retain these instructions for future use.
2. Improper installation may result in the risk of fire, electric shock, or serious injury to persons.
3. Check that the mains voltage corresponds with the rating of the appliance before operating.
4. Unplug from electrical supply source before cleaning.
5. The fan should be placed on a flat and stable surface when operating to avoid overturning.
6. Do not use in wet conditions or areas of high humidity.
7. Do not insert objects through the bars of the guard.
8. Do not use outdoors.
9. Unplug from mains if not in use.
10. Do not insert fingers or other objects through the fan guard.
11. Do not use if any parts are damaged or missing.
12. If using an extension cord with this product, the marked electrical rating of the cord set, or
extension cord should be at least as great as the electrical rating of the product. Never use the
plug with an extension cord unless of the plug can be fully inserted into the extension cord
13. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
14. This appliance can be used by children aged 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved.
15. Children shall not play with the appliance.
16. This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the appliances by a person responsible
for their safety.
17. Ensure that the fan is switched off from the supply mains before removing the safety guard.
18. Warning! Never use without the guards in place. After assembly, do not remove the guards
during use or cleaning.

Technical specification

Model No: CHGF210
Rated Voltage: 220-240V ~50/60Hz
Assembly
Fan assembly
1. Position the rear guard over the motor shaft, ensuring that the notches are correctly aligned
and then fixed with the three screws.
2. Align the fan blade with the flat part on the motor shaft, locate fully and secure by tightening the
fan blade screw fully.
3. Position the front guard against the rear guard and holds both guards together and close the
clip then tighten the screw and the nut at the bottom of the guard.
1
Power: 55W