Champion CHGF220 User Manual page 3

Stand assembly
1. Insert the pole to the base and put the fixed circle and the steady plate under the base, using
the bolt and nut slice provided to tighten them as shown.
2. Unscrew the height adjustment knob and pull up the inner tube to adjust the height, ensuring
that the knob is fully tightened before proceeding.
3. Position the fan head motor either side as shown in fig 2 and insert the tilt control bolt to pas-
ses through the square hole of the coupling and the lower hole of inner tube. Fully tighten the
small screw that is already located in the coupling and then fit the knob onto the tilt control bolt
and lightly tighten.
4. Insert the locking knob through the top hole of the coupling, adjust the fan head to the desired
position and firmly tighten screw and the tilt control.
Diagram
1. Front guard
2. Fan blade
3. Screw and flat washer
4. Fan blade screw
5. Rear guard
6. Motor shaft
7. Motor head
8. Oscillation knob
9. Rotary switch
Oscillation knob
Locking knob
Tilt control bolt
Tube cover
Height adjust-
ment knob
Rotary Switch
Screw
Knob
Inner tube
10. Knob
11. Power cord
12. Inner tube
13. Height adjustment knob
14. Pole
15. Base
16. Steady plate
17. Nut slice
18. Bolt
EN
2