Wiring Diagram - Klarstein VIRTUOSA 5 Manual

WIRING DIAGRAM

The connection to the power supply must be made in accordance with the relevant
standard or via single-pole circuit breaker. The wiring method is shown below.
• If the cable is damaged or needs to be replaced, this should be done by a
service technician with the correct tools to avoid accidents.
• If the appliance is connected directly to the power supply, an omnipolar circuit
breaker with a minimum distance of 3 mm between the contacts must be
installed.
• The electrician must make sure that the electrical connection has been made
correctly and complies with the safety regulations.
• The cable must not be kinked or compressed.
• The cable must be checked regularly and may only be replaced by a suitably
qualified person.
EN
41