Tourmaster Synergy Pro-Plus User Manual & Installation Manual page 9

Option 2: Synergy
The following connection instructions apply to the Synergy
when used separately from Synergy
with jacket or vest, see pages 6-7)
1. Remove male end of connecting plug located inside zippered storage pocket found
on left side of the exterior upper leg.
2. With the vehicle motor running, firmly plug the male end of connecting cord into the
female plug of the power lead harness that has been properly installed on your
vehicle's battery system using the instructions provided in this manual
(see pages 4-5).
(NOTE: Synergy
connecting plugs on each leg opening. These plugs can be used to connect
to motorcycle specific 12V heated insoles or Synergy
The power rating and draw of the insoles and socks must not exceed 6 watts
and 0.5 amps per foot. Exceeding limits will void warranty.)
3. With garment securely connected, your jacket or vest is safe to turn on and operate
using the built-in waterproof 3-setting LED smart soft touch controller or Bluetooth
app. (Smart soft touch controller instructions can be found on pages 13-14.
Bluetooth operating instructions on separate sheet included with garment.)
®
NOTE: Firmly plug in all connectors to ensure no metal is showing.
CAUTION: Prior to use, double check that wiring does not interfere with
normal operation of your vehicle.
BT Pro-Plus 12V Heated Pant Connection Instructions
®
BT Pro-Plus heated pants are equipped with male
®
BT Pro-Plus jacket or vest. (For connection
®
BT Pro-Plus pant
®
Pro-Plus heated socks.
®
9
®