Advertisement
New for Tourmaster
tional 12v lithium-ion battery power source. 12v lithium battery information can be found
on the back cover of this manual and is available from your preferred Tourmaster
Run times for each garment using compatible 12v lithium-ion battery are as follows, and
approximation based on full charge.
SYNERGY
SYNERGY
GARMENT
®
JACKET
VEST
PANTS
1.
Locate the battery compartment on each garment.
• On the jacket/vest, this compartment is on the lower left torso, and is accessible
by a waterproof zipper.
• On pants, this compartment is located on the left side just below the waist.
2a. On the jacket/vest, locate the male connecting plug, and feed through the yellow
port found on the inside of the jacket.
2b. On the pants, the male connecting plug is found inside the battery compartment. No
additional steps are needed.
3.
Firmly plug the male end of the connector into the female port found on the
Tourmaster
Synergy
®
4.
With the lithium-ion battery firmly installed, safely secure the battery inside the
holding compartment by zipping closed.
5.
Power on, and use the garment using the same steps when connecting directly
to the bike's power source.
NOTE: To charge your Tourmaster
simply plug the male connector into the female port of the battery, and plug
charger into a suitable wall outlet. The battery is fully charged when light on
charger turns from RED to GREEN. Approximate full charge time is 3:50 hours.
(NOTE: Tourmaster
will power from the 12v lithium-ion battery when connected to ject/vest/pants.
Connecting additional accessories to the jacket/vest/pants will decrease runtime.)
Synergy
Pro-Plus 12v heated riding apparel is the use of an op-
®
®
PRO-PLUS 12-VOLT LITHIUM-ION RUNTIMES
®
LOW
5.0 Hours
5.0 Hours
3.0 Hours
Pro-Plus 12v lithium-ion battery.
®
Synergy
®
Synergy
Pro-Plus 12v gloves, glove liners, and sock liners
®
®
MEDIUM
2.5 Hours
2.5 Hours
2.0 Hours
Pro-Plus lithium-ion battery,
®
3
dealer.
®
HIGH
1.5 Hours
1.5 Hours
1.5 Hours
Advertisement
Need help?
Do you have a question about the Synergy Pro-Plus and is the answer not in the manual?