Kyocera F-1000A User Manual page 15

Tools Menu
9. After setting the ccpy on.prn properties, select [Project>Build] from the drop down menu. This will launch
the "Project Build" dialogue box where you can check/configure the Project Settings as follows:
a. Build Target – defines the target storage device for the project file (IC Card in printer, Hard
Disk/Micro Drive in printer, Export File for EPROM, or Export File for JEIDA (PCMCIA) Card.
b. Format IC card – will format the PCMCIA or CF card before building the project file to the card.
c. Configure – defines the IC Card type and size.
d. Select Printer – sets the target printer.
e. Send to Printer – sends the project file to the printer.
10. After all the Project Build settings have been completed, click on the [Send to printer] button, a WARNING
message will display warning the Format of the Compact Flash Card will erase all data on that Compact
Flash Card.
11. Click on the [OK] button, and a message will display "Project was written to the print spooler".
12. The printer LCD will flash "Processing" and then return to the "Ready" state. Turn the printer power "OFF"
and then "ON" to start the Multi-Part Form Macro.
13. Send your print data to the printer. The Multi-Part Form will be active for any print jobs sent to the printer.
NOTE: Using Logical Printer Ports, it is possible to accommodate multiple Multi-Part Forms projects on one printer
or to dedicate to one specific Printer Port using a PRESCRIBE RWER command to trigger the ccpy on.prn at the
Start of Job String.
IC Link for Windows
Multi-Part Form Creator (continued)
{PAGE }