Annex 1 - Pairing An Rf Device; Annex 2 - Unpairing An Rf Device - Ferroli Connect CRP Installation And User Manual

ANNEX 1 - PAIRING AN RF DEVICE

NOTES Before pairing an RF device to a zone, make sure another device has not already been assigned to the
zone.
If this procedure has already been carried out for the selected zone, the new device will replace the old
one.
To pair an RF device to a zone, proceed as follows.
From Connect CRP:
• Access the "TECHNICAL" menu (see "6.1 Accessing the TECHNICAL menu" on page 101)
• Follow the path
MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED ZONE)
>> RF DEVICE >> PAIRING
• Press the
button: the message "RF DEVICE PAIRING IN PROGRESS ..." will appear on the screen
From CRP ZONE:
• Press button B on the thermostat for 1-2 sec.
• Wait for the pairing to end.
If the pairing occurs without problems, a screen with
green background will appear with the message OK.
In case of problems during pairing, a screen with red
background will appear with the message KO.
In the latter case, try repeating the operation, starting
from point 2
NOTE Before pairing an RF device, make sure it has been reset by pressing button B for more than 5 seconds
(For the complete operation, see the RF device reference manual).

ANNEX 2 - UNPAIRING AN RF DEVICE

To unpair an RF device previously paired to the Connect CRP, proceed as follows.
From Connect CRP:
• Access the "TECHNICIAN" menu (see "6.1 Accessing the TECHNICAL menu" on page 101)
• Follow the path - MENU >> TECHNICAL >> INSTALLATION >> ZONES MANAGER >> (CHOOSE THE DESIRED
ZONE) >> RF DEVICE >> LEAVE
• Press the
button.
• The message "LEAVING RF DEVICE IN PROGRESS..." will appear on the screen
From CRP ZONE:
• Press button B on the thermostat for 1-2 sec.
• Wait for the unpairing to finish.
If the operation occurs without problems, a screen with
green background will appear with the message OK.
NOTE: If the Connect CRP receives no response from the RF device within one minute, the relevant zone
is automatically unpaired from the RF device.
106
EN
cod. 3542B380 - Rev 00 - 05/2022
fig. 75 - CRP ZONE
fig. 76