Ferroli Connect CRP Installation And User Manual page 79

2. Secure the back panel directly to the wall or to 2- or 3-module junction boxes using the screw seats, making sure
to run the wires through the slot as indicated in fig. 7.
3. Make the electrical connections following the connection diagram
NOTES For the device to function correctly, the power supply provided must be used.
For the correct modbus connection it is advisable to use shielded twisted cables suitable for RS485
transmission with section not less than 0.34 mm
For the power supply, do not use cables with section less than 0.5 mm
Do not use cables longer than 25 m.
4. Bring the front panel to the wall plate by first matching the two catches at the top with the seats on the back panel.
5. Press the lower part of the panel until it is completely closed and secured.
MAX LOAD 5A
250Vac / 30Vdc
Ø 0,5÷1,5
M
A
B
E
N L
fig. 9
cod. 3542B380 - Rev 00 - 05/2022
fig. 7
fig. 8
2 .
NOTE
If properly closed you should hear a click.
2
EN
79