Cisco Catalyst 3650 Series Manual page 25

Switch Installation
This chapter describes how to install and connect a Catalyst 3650 switch. It also includes planning and
cabling considerations for stacking switches. Read the topics and perform the procedures in this order:
•
•
•
•
•
•
For initial switch setup, how to assign the switch IP address, and for powering information, see the
switch getting started guide on Cisco.com.
Preparing for Installation
•
•
•
Safety Warnings
This section includes the basic installation caution and warning statements. Translations of the warning
statements appear in the Regulatory Compliance and Safety Information for the Catalyst 3650 Switch
document available at Cisco.com. Read this section before you start the installation procedure.
Before working on equipment that is connected to power lines, remove jewelry (including rings,
Warning
necklaces, and watches). Metal objects will heat up when connected to power and ground and can
cause serious burns or weld the metal object to the terminals. Statement 43
Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury
Warning
and equipment damage. Statement 48
OL-29734-01
Preparing for Installation, page 2-1
Planning a Switch Data Stack, page 2-4
Installing the Switch, page 2-9
Connecting to the StackWise Ports, page 2-15
Connecting Devices to the Ethernet Ports, page 2-19
Where to Go Next, page 2-22
Safety Warnings, page 2-1
Installation Guidelines, page 2-3
Tools and Equipment, page 2-4
C H A P T E R
Catalyst 3650 Switch Hardware Installation Guide
2
2-1