Cisco Catalyst 3650 Series Manual page 14

Front Panel
Table 1-4
Port Mode
PoE+
1. Only switches with PoE or PoE+ ports.
USB Console LED
The USB console LED
Table 1-5
Color
Off
Green
ACTV LED
Table 1-6
Color
Off
Green
Catalyst 3650 Switch Hardware Installation Guide
1-12
Meaning of Switch LED Colors in Different Modes (continued)
Port LED Color
1
Off
Green
Alternating
green and
amber
Blinking amber PoE+ is off due to a fault or because it has exceeded a limit set in
Amber
(Figure 1-4) shows whether there is an active USB connection to the port.
USB Console Port LED
Description
USB console is disabled.
USB console is enabled.
ACTV LED
Description
Switch is not the active switch.
Switch is the active switch or a standalone switch.
Meaning
PoE+ is off.
If the powered device is receiving power from an AC power source,
the port LED is off even if the device is connected to the switch port.
PoE+ is on. The port LED is green when the switch port is providing
power.
PoE+ is denied because providing power to the powered device will
exceed the switch power capacity.
the switch software.
PoE+ faults occur when noncompliant cabling or
Caution
powered devices are connected to a PoE+ port. Use only
standard-compliant cabling to connect Cisco prestandard
IP Phones and wireless access points or
IEEE 802.3af-compliant devices to PoE+ ports. You must
remove from the network any cable or device that causes
a PoE+ fault.
PoE+ for the port has been disabled.
PoE+ is enabled by default.
Note
Chapter 1 Product Overview
OL-29734-01