Panel Switch (Sw) Parameters; Virtual Controllers; Fixed Controller (Fix) Parameters - Kurzweil ExpressionMate User Manual

Panel Switch (SW) Parameters

The ExpressionMate has two Panel Switches on the right side of
the unit. Each of these functions exactly like the switch pedals;
you can choose between momentary and toggle switches, and set
on and off values for each one.
PARAMETER
SWITCH TYPE
ON/OFF DESTINATION
ON VALUE
OFF VALUE
ENTRY VALUE
EXIT VALUE

Virtual Controllers

Every Zone has six ÒvirtualÓ controllers; that is, they arenÕt
physical controllers like Mod Wheels or buttons, but they can act
in very similar ways. The ExpressionMateÕs virtual controllers
are:
Fixed Controllers (FIX1, FIX2, and FIX3)
•
MIDI Remap Controllers (MAP1, MAP2, and MAP3)
•

Fixed Controller (FIX) Parameters

The Fixed controllers each send a Þxed value automatically,
whenever you choose a new Setup. Though you can do this with
any controller (by setting Entry and Exit values), you may prefer
to use the Fixed Controllers instead, leaving the Ribbon and other
controllers free for more complex uses.
Note that with the Fixed controllers, the Entry and Exit Values
determine the On and Off Values. Also note that when you
choose a Setup, the ExpressionMate sends FIX1 Þrst, then FIX2,
then FIX3. This is especially useful for sending Bank Select and
Program Change messages when selecting a Setup. (For an
example of how to do this, see the discussion of the PrgChg
Special Function on page 53.)
RANGE OF VALUES
Momentary, Toggle
MIDI Destination List
0–127
0–127
None, On, Off, Current
None, On, Off
Editing and Creating Setups
Fixed Controller (FIX) Parameters
DEFAULT
Moment
SW1: ARP1
SW2: ARP2
127
0
None
None
43