Inserting/Removing The Battery Pack; Checking The Battery Charge Level; Using The Appliance; Switching On/Off - Parkside PPHA 20-Li B2 Original Instructions Manual

♦ Push the battery pack
♦ Switch off the charger
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Inserting/removing the battery
pack
Inserting the battery pack
♦ Allow the battery pack
the appliance.
Removing the battery pack
♦ Press the release button
battery pack .

Checking the battery charge level

♦ Press the battery charge level button
check the status of the battery (see also main
diagram). The status will be shown on the
battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Using the appliance

Switching on/off
Switching on
♦ First, press the safety lock-out
♦ Then press and hold the ON/OFF switch
You can now release the safety lock-out
Switching off
♦ Release the ON/OFF switch
NOTE
► For safety reasons, the ON/OFF switch
cannot be locked.
8
GB │ IE
│
■
into the appliance.
for at least 15 minutes
to click into place in
and remove the
to
as follows:
.
.
.
.

Setting the cut depth

Use the dial to adjust the cutting depth (0–2 mm)
in 1/10 mm increments using the cutting depth
scale . This can then be read via the
Vacuuming dust/chips (see fig. A)
WARNING!
Always wear a dust mask!
RISK OF INJURY!
► Always switch the appliance off and remove
the battery before carrying out any work on
the appliance.
Adjustable chip ejector (left/right)
♦ Unlock the chip ejector
opposite direction to the arrow (from the
"LOCK" position).
♦ Pull the chip ejector
♦ The chip ejector
plane on the left or the right. Make sure that
the tab on the chip ejector
corresponding recess on the housing.
♦ Push the chip ejector
♦ Lock the chip ejector
position "LOCK".
External extraction
When using a workshop extractor, for example, it
may be necessary to use the adapter for external
extraction . The workshop vacuum cleaner must
be suitable for the material being processed.
Connection
♦ Push the adapter for external extraction
firmly onto the chip ejector
♦ Push the hose of a suitable workshop vacuum
cleaner onto the chip ejector
for external extraction
Removal
♦ Pull the hose of the workshop vacuum cleaner
off the chip ejector
♦ Pull off the adapter for external extraction
if attached.
marking.
by turning it in the
out of the appliance.
can be attached to the
fits into the
into the appliance.
by turning it to the
.
or the adapter
, as applicable.
or the adapter.
PPHA 20-Li B2
,