Specifications - Makita 1806B Instruction Manual

ENGLISH (Original instructions)
1-1. Knob
2-1. Switch trigger
3-1. Lock button / Lock-off button
3-2. Switch trigger
4-1. Hex wrench
4-2. Bolt
5-1. Adjusting screw
5-2. Planer blade
5-3. Notch in the blade
5-4. Drum cover

SPECIFICATIONS

No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavorable
mains conditions can have adverse effects to the operation
of other equipment. With a mains impedance equal or less
than 0.41 Ohms it can be presumed that there will be no
negative effects. The mains socket used for this device must
be protected with a fuse or protective circuit breaker having
slow tripping characteristics.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Explanation of general view
5-5. Drum
6-1. Triangular rule
6-2. Screwdriver
7-1. Nozzle
7-2. Screwdriver
8-1. Nozzle
8-2. Vacuum cleaner
9-1. End
9-2. Start
10-1. Sharpening holder
Model
Planing width
Planing depth
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 92 dB (A)
pA
) : 103 dB (A)
WA
ENE001-1
Vibration
The vibration
ENF002-2
determined according to EN60745:
Work mode : planing softwood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF100-1
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
ENG905-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
11-1. Wing nut
11-2. Blade (A)
11-3. Blade (B)
11-4. Side (D)
11-5. Side (C)
13-1. Limit mark
14-1. Chip cover
14-2. Screwdriver
15-1. Brush holder cap
15-2. Screwdriver
1806B
170 mm
2 mm
15,000
529 mm
9.0 kg
/II
total value (tri-axial
2
) : 2.5 m/s
h
2
ENG900-1
vector sum)
ENG901-1