General Safety Information; Receiving, Moving, And Unpacking - Gardner Denver RGD Series Instruction Manual

GENERAL SAFETY INFORMATION

1. PRESSURIZED DEVICES:
This equipment is a pressure containing
device.
• Do not exceed maximum operating
pressure as shown on equipment
serial number tag.
• Make sure equipment is depressurized before working
on or disassembling it for service.
2. ELECTRICAL:
This equipment requires electricity to
operate.
• Install equipment in compliance with
all applicable electrical codes.
• Standard equipment is supplied with electrical en-
closures not intended for installation in hazardous
environments.
• Disconnect power supply to equipment when perform-
ing any electrical service work.
3. BREATHING AIR:
• Air treated by this equipment may not
be suitable for breathing without fur-
ther purification.
Refer to applicable standards and
specifications for the requirements for
breathing quality air.

RECEIVING, MOVING, AND UNPACKING

A. RECEIVING
This shipment has been thoroughly checked, packed and
inspected before leaving our plant. It was received in good
condition by the carrier and was so acknowledged.
Check for Visible Loss or Damage. If this shipment shows
evidence of loss or damage at time of delivery to you, in-
sist that a notation of this loss or damage be made on the
delivery receipt by the carrier's agent.
B. UNPACKING
Check for concealed loss or damage. When a shipment
has been delivered to you in apparent good order, but
concealed damage is found upon unpacking, notify the
carrier immediately and insist on his agent inspecting the
shipment. Concealed damage claims are not our responsi-
bility as our terms are F.O.B. point of shipment.
C. MOVING
In moving or transporting dryer, do not tip dryer onto its
side.
D. STORAGE
IMPORTANT: Do not store dryer in temperatures above
130°F (54.4°C).
1