Advertisement
2.1
Transport mode
2.2
Diagnostics connector
2.3
Unpacking and setting up the vehicle
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
H02713-01
handing it over to the customer.
The diagnostics connector is located under the front rider's seat.
H01949-01
Preliminary work
–
Remove the box.
Main work
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
–
Check the vehicle for transport damage.
H05199-01
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
–
Remove cable ties
to the side.
–
Remove cable ties
S05294-10
1
and hang the combination instrument
2
and hang the handlebar to the side.
SETUP 2
3
Advertisement
